Online Catalogue
.
 
HomeSite MapTerms & CondsContact Us Login

Order by Post - click here... Telephone: 0845 680 0296 or 01285 654241

Soaker HoseThis porous hosepipe is designed to water gardens easily, economically and effectively; the hose can be connected to a water butt or attached to the main water supply. It can be used on the surface or buried.

Its versatility allows it to be used in all areas of the garden, including; shrubberies, annual flower beds, lawns, orchards and soft fruit, vegetables and the greenhouse border.
It may also be used for specialist purposes (for example to create a 'bog garden') and in the greenhouse to irrigate sand beds or capillary matting.

Accessories
The Soaker Hose Kit comes with a selection of fittings. Additional fittings are available.
The hose is the same size as standard hose pipe.

Water Supply
Soaker Hose requires only a low water pressure to operate. It may be connected to either a water butt or a mains supply. If it is to be connected to a water butt, a suitable tap should be fitted to the butt (available as an accessory). The Hose will release water over its whole length; therefore a suitable length of normal hosepipe should be fitted between the water supply and where the water is required.

Note - to keep water in the butt fresh and the pipe free of Bacteria, treat the water with Citrox.

Water Pressure
If mains water is used as the source of supply, the tap should only be partially turned on, as very low pressure is needed. If the supply is from a water butt, the head of water should be at least 1.2 metres (4 feet above the level to be watered.

Water Release
Water seeps through the porous walls of the hose into the soil. The water will spread about 0.5 metres (20 inches) either side of the pipe dependant on soil-type. On cultivated ground the pipes should be laid about 1 metre apart, but in lawns they should be buried about 15-30 cm (6-12 inches) apart to reduce the risk of striping.

The length of any single pipe run should not exceed 50 metres (160 feet), or the pressure may be insufficient to allow uniform water release along the length of the pipe.

Temporary Installation
For a temporary installation the Agralan Soaker Hose should be laid on the surface of the ground. This method is preferred where the ground is likely to be disturbed regularly (e.g. in vegetable plots, annual flower beds and greenhouse beds).


Permanent Installation
For permanent installation the hose should be buried 10-15cm (4-6 inches) beneath the soil surface. This method is preferred in areas of perennial plants where the ground is unlikely to be disturbed. (e.g. in shrubberies, orchards, lawns etc). In deep rooted crops, the pipe may be installed somewhat deeper, as long as it remains within the topsoil.
Note: by applying water at a depth, the growth of annual weeds is not encouraged.




Soaker Hose
Enter e-mail address to tell a friend

UK Mainland Packaging & Posting Only £1.95!